Flex AWD V6-3.5L (2009)
-
Remove the booster rod and washer from the brake pedal.
7. Remove and discard the 4 nuts and remove the brake booster.
-
To install, tighten the new nuts to 25 Nm (18 lb-ft).
8. NOTICE: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch or the speed control deactivator
switch. These switches must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest
position. Installing these switches with the brake pedal in any other position will result in incorrect adjustment and may damage the
switches.
To install, reverse the removal procedure.
