Flex AWD V6-3.5L (2009)
metal shiny. Some staining of the metal surfaces is normal.
5. Make sure the 2 locating dowel pins are seated correctly in the cylinder block.
99. Rotate the crankshaft clockwise and align the timing marks on the VCT assemblies as shown.
100. NOTE: The Camshaft Holding Tool will hold the camshafts in the Top Dead Center (TDC) position.
Install the Camshaft Holding Tool onto the flats of the LH camshafts.
101. NOTE: The Camshaft Holding Tool will hold the camshafts in the TDC position.
Install the Camshaft Holding Tool onto the flats of the RH camshafts.
102. Remove the 3 bolts and the RH VCT housing.
103. Remove the 3 bolts and the LH VCT housing.
104. Remove and discard the VCT housing seals.