Flex AWD V6-3.5L (2009)
Drive Belt: Service and Repair
Power Steering Pump Belt
Power Steering Pump Belt
Removal
NOTICE: Under no circumstances should the accessory drive belt, tensioner or pulleys be lubricated as potential damage to the belt material
and tensioner damping mechanism will occur. Do not apply any fluids or belt dressing to the accessory drive belt or pulleys.
1. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the generator
pulley.
2. Remove the RF wheel and tire.
3. Remove the 7 pin-type retainers and the RH splash shield.
4. Position the accessory drive belt off the crankshaft pulley.
5. Position the Stretchy Belt Remover on the power steering pump pulley belt as shown.
6. NOTE: Feed the Stretchy Belt Remover on to the power steering pump pulley approximately 90 degrees.
Turn the crankshaft clockwise and feed the Stretchy Belt Remover evenly on the power steering pump pulley as shown.
7. Remove the power steering pump belt.
-
Fold the Stretchy Belt Remover under the inside of the power steering pump belt as shown.
-
In one quick motion, firmly pull the Stretchy Belt Remover out of the RH fender well, removing the coolant pump belt.
