Flex AWD V6-3.5L (2009)
10. NOTE: It may be necessary to rotate the crankshaft slightly to remove slack from the timing chain and install the tensioner.
Install the primary tensioner and the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
-
Remove the lockpin.
11. As a post check, verify correct alignment of all timing marks.
12. Install new VCT housing seals.
13. NOTE: Make sure the dowels on the VCT housing are fully engaged in the cylinder head prior to tightening the bolts.
Install the LH VCT housing and the 3 bolts.