Flex AWD V6-3.5L (2009)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Drain the engine coolant.
4. Remove the rear subframe.
5. Remove the front auxiliary evaporator inlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the front auxiliary evaporator outlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
7. Release the 2 front auxiliary heater line heater hose clamps and disconnect the hoses.
8. Release the 2 rear auxiliary heater hose clamps at the floorpan connection and disconnect the heater hoses.
9. Remove the rear auxiliary evaporator inlet line fitting nut and disconnect the fitting.
-
Discard the O-ring seal.
-
To install, tighten to 15 Nm (133 lb-in).