Flex AWD V6-3.5L (2009)
Hose/Line HVAC: Service and Repair
Compressor to Condenser Discharge Line
Compressor to Condenser Discharge Line
Removal and Installation
1. Recover the refrigerant.
2. Remove the rear A/C compressor bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
3. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
4. Disconnect the A/C pressure transducer electrical connector.
5. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (133 lb-in).
6. Remove the compressor-to-condenser discharge line.
7. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Add the correct amount of clean PAG oil.