Flex AWD V6-3.5L (2009)
Multiple Junction Connector: All Technical Service Bulletins
Engine Controls - MIL ON/Multiple DTC's Set
TSB 09-11-11
06/15/09
DTCS P2110, P2111, P2135 OR P2112 - POSSIBLE
WATER IN PCM CONNECTOR - BUILT BEFORE
10/22/2008
FORD:
2009 Flex
ISSUE
Some 2009 Ford Flex vehicles built prior to 10/22/2008 may exhibit diagnostic trouble codes (DTCs) P2110, P2111, P2135 or P2112. Check for water
in the Powertrain Control Module (PCM) connectors.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
If water is present in the PCM connectors it is not necessary to replace the PCM and/or Throttle Body assembly for this condition.
1. Inspect the PCM connectors for signs of water intrusion.
2. If there is evidence of water in the PCM connectors, make sure PCM connectors are clean and dry prior to reconnecting them to the PCM.
3. Install revised cowl vent grill per Workshop Manual, Section 501-02.
4. Rerun self test, if DTCs return proceed to the appropriated Powertrain Control/Emission Diagnostic Manual (PC/ED) diagnostic section. If no DTC's
are present, return the vehicle to the customer.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
MTO91111
Use SLTS Operations If
Actual
Available; Claim Additional
Time
Diagnosis Or Labor
Performed As Actual Time.
DEALER CODING
CONDITION
BASIC PART NO.
CODE
74022A68
68
Disclaimer
