Flex AWD V6-3.5L (2009)
Catalytic Converter: Service and Repair
Catalytic Converter - LH
Catalytic Converter - LH
Removal and Installation
1. NOTE: Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.
With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the Catalyst Monitor Sensor (CMS) electrical connector.
3. Remove the exhaust Y-pipe. For additional information, refer to Exhaust Y-Pipe See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Pipe/Service and Repair/Exhaust Y-Pipe.
4. Remove the 2 catalytic converter support bracket-to-transmission bolts.
-
To install, tighten to 48 Nm (35 lb-ft).
5. Remove the 4 nuts and the LH catalytic converter.
-
Discard the nuts and gasket.
-
To install, tighten to 40 Nm (30 lb-ft).
6. Inspect the exhaust manifold studs for damage.
-
If damaged, replace stud(s), or if stud comes out when removing nut(s), replace the stud(s).
-
To install, tighten to 25 Nm (18 lb-ft).
7. To install, reverse the removal procedure.
-
Install a new gasket and nuts.