Flex AWD V6-3.5L (2009)
Evaporative Canister Filter: Service and Repair
Dust Separator
Dust Separator
Removal and Installation
1. Remove the Evaporative Emission (EVAP) canister. For additional information, refer to Evaporative Emission Canister See: Evaporative
Emission Control Canister/Service and Repair/Evaporative Emission Canister.
2. Depress the locking tab outward, rotate the EVAP canister vent solenoid clockwise and remove it from the dust separator.
-
Apply clean engine oil to the EVAP canister vent solenoid O-ring seal upon installation.
3. Release the 3 retaining tabs and remove the dust separator.
4. To install, reverse the removal procedure.
