Flex AWD V6-3.5L (2009)
1. With vehicle in NEUTRAL, position it on a hoist.
2. Release the fuel system pressure.
3. NOTE: Some residual fuel may remain in the fuel tubes after releasing the fuel system pressure. Upon disconnecting or removing any fuel tubes,
carefully drain any residual fuel into a suitable container.
Disconnect the fuel supply tube-to-fuel rail jumper tube quick connect coupling.
4. Disconnect the fuel vapor tube-to-Evaporative Emission (EVAP) canister purge valve quick connect coupling.
5. Remove the nut from the stud and release the fuel tubes from the bundle retainer.
-
To install, tighten to 20 Nm (177 lb-in).
6. Disconnect the fuel vapor tube-to-EVAP canister quick connect coupling.
7. Disconnect the fuel supply tube-to-fuel tank jumper tube quick connect coupling.
8. Remove the nut and position the EVAP canister shield aside.
-
To install, tighten to 9 Nm (80 lb-in).
9. Remove the fuel tube bundle shield nut.
-
To install, tighten to 9 Nm (80 lb-in).
10. Release the fuel tube bundle separators.
11. Release the fuel tubes from the fuel tube bundle shield and remove the tubes.
12. To install, reverse the removal procedure.
