Flex AWD V6-3.5L (2009)
4. Install the safety canopy module A-pillar bolt.
-
Tighten to 8 Nm (71 lb-in).
5. Install the safety canopy module front tether and bolt.
-
Tighten to 8 Nm (71 lb-in).
6. Attach the safety canopy module pin-type retainers to the A-pillar moulding.
7. Install the safety canopy module middle bolt.
-
Tighten to 8 Nm (71 lb-in).
8. Install the safety canopy module bolt C-pillar bolt(s).
-
RH safety canopy has 1 C-pillar bolt, LH safety canopy has 2 C-pillar bolts.
-
Tighten to 8 Nm (71 lb-in).
9. Install the front and rear safety canopy module canister bolts.
-
Tighten to 8 Nm (71 lb-in).
10. If equipped, connect the 2 rear moonroof drain hose clips to the safety canopy module canister.
11. NOTE: Attach the rear tether as shown to prevent interference when installing the D-pillar trim panel.
NOTE: Do not separate the rear tether from the routing clip. If the rear tether and routing clip become separated, use masking tape to reattach.
Attach the rear tether and routing clip and install the tether anchor and bolt.
-
Tighten to 8 Nm (71 lb-in).
12. Connect the safety canopy module electrical connector.
13. Install the headliner.
14. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering.
