Flex AWD V6-3.5L (2009)
6. NOTE: For retainer clarity, inside of cushion side shield shown.
Separate the cushion side shield from the cushion frame.
1. Remove the screw at the back of the cushion side shield.
2. Remove the screw at the side of the cushion side shield.
3. Remove the screw at the front of the cushion side shield.
4. Pull out on the cushion side shield to release the 4 clips and separate.
-
If equipped, disconnect the seat control switch electrical connector.
7. Remove the outboard upper recliner cover.
1. Pull at the front and release the clip.
2. Pivot the top of the outboard upper recliner cover back and remove.
-
Pull the fold-flat release strap out through the opening.
8. Using the strap on the outboard recliner, fold the backrest down to the fold-flat position.
9. Separate the wire harness and cable retainers.
1. Remove the pin-type retainers, release the cushion trim cover outboard J-clips and position the flap aside.
2. If equipped, separate the lumbar cable retainers.
3. If equipped, pull the manual lumbar cable cover out of the adjuster.
4. Separate the side air bag module wire harness pin-type retainers.
