Flex AWD V6-3.5L (2009)
4. Connect the large electrical connector.
-
Pivot the connector position assurance lever toward the RCM, drawing the connector in to the RCM.
-
Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
5. Connect the small electrical connector.
6. Install the LH and RH floor console lower trim panels.
7. Install the front seats.
8. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering.
9. If a new RCM was installed, carry out the appropriate steps to complete the Programmable Module Installation (PMI) procedure. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
