Flex AWD V6-3.5L (2009)
Tie Rod: Service and Repair
Inner Tie Rod
Removal
NOTICE: The boots and clamps are designed to provide an airtight seal and protect the internal components of the steering gear. If the seal is
not airtight, the vacuum generated during turning will draw water and contamination into the gear, causing failure of the steering gear
components. Zip ties must not be used as they do not provide an airtight seal.
NOTICE: The inner ball joint grease is not compatible with water contamination. Do not allow water to become trapped in the grease or
degradation and failure of the joint may occur.
NOTICE: If present, the orientation of the vent tube must be noted so the boots and vent tubes can be installed in the correct location.
Incorrect orientation may lead to improper ventilation and steering gear failure.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Loosen the tie-rod jam nut.