Flex AWD V6-3.5L (2009)
3. Install the transaxle support insulator bracket and install the 4 transaxle support insulator bracket nuts.
-
Tighten to 63 Nm (46 lb-ft).
4. Using the floor jack and Oil Pan Holding Fixture, raise the transaxle and install the transaxle support insulator through bolt.
-
Tighten to 175 Nm (129 lb-ft).
5. Remove the floor jack and the Oil Pan Holding Fixture.
6. Install the battery tray and bracket, install the battery tray bolt and nut.
-
Tighten to 9 Nm (80 lb-in).
7. Install the 2 lower battery tray bracket bolts.
-
Tighten to 9 Nm (80 lb-in).
8. Attach the 5 pin-type wiring harness fasteners to the battery tray.
