Flex AWD V6-3.5L (2009)
Flex Plate: Removal and Replacement
Flexplate and Crankshaft Rear Seal - Exploded View
Lower End Components - Exploded View, Flexplate and Crankshaft Rear Seal
1. For additional information, refer to the procedures.
Flexplate
Flexplate
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the transaxle.
3. NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.
Remove the bolts and the flexplate.
-
To install, tighten to 80 Nm (59 lb-ft).
4. To install, reverse the removal procedure.