Flex FWD V6-3.5L (2010)
No
GO to AA2.
-------------------------------------------------
AA2 CHECK FOR VOLTAGE TO THE TRAILER TOW CONNECTOR
-
Place the headlamp switch in the OFF position.
-
Disconnect: Trailer Tow C4099.
-
Place the headlamp switch in the PARKING LAMPS ON position.
-
Measure the voltage between the trailer tow C4099-6, circuit CAT11 (BN), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
INSTALL a new trailer tow connector. TEST the system for normal operation.
No
GO to AA3.
-------------------------------------------------
AA3 CHECK THE TRAILER TOW PARKING LAMP RELAY
-
Place the headlamp switch in the OFF position.
-
Disconnect: Trailer Tow Parking Lamp Relay.
-
Substitute a known good relay.
-
Place the headlamp switch in the PARKING LAMPS ON position.
-
Measure the voltage between the trailer tow C4099-6, circuit CAT11 (BN), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
REMOVE the known good relay. INSTALL a new trailer tow parking lamp relay. TEST the system for normal operation.
No
REMOVE the known good relay. GO to AA4.
-------------------------------------------------
AA4 CHECK FOR VOLTAGE TO THE TRAILER TOW PARKING LAMP RELAY COIL
-
Place the headlamp switch in the PARKING LAMPS ON position.
-
Measure the voltage between the trailer tow parking lamp relay pin 1, circuit CLS30 (VT/WH), harness side and ground.
