Flex FWD V6-3.5L (2010)
3. Remove the 4 retainers and the underbody shield.
All vehicles
4. Remove the 2 RH lower pin-type retainers from the engine splash shield and position the shield aside.
Vehicles equipped with EPAS
5. Remove the RH and LH exhaust flexible pipes. For additional information, refer to Exhaust System &/or Catalytic Converter.
Vehicles equipped with Hydraulic Power Assist Steering (HPAS)
6. Remove the engine exhaust Y-pipe. For additional information, refer to Exhaust System &/or Catalytic Converter.
7. Remove and discard the stabilizer bar bracket-to-front subframe bolts.
Vehicles equipped with EPAS
8. NOTE: RH shown, LH similar.
Remove and discard the upper stabilizer link nuts.
All vehicles
9. NOTE: The hex-holding feature can be used to prevent turning of the stud while removing the nut.
NOTE: RH shown, LH similar.
Remove and discard the tie-rod end nuts.
