Flex FWD V6-3.5L (2010)
Install the 2 new rear subframe bolts.
-
Tighten to 150 Nm (111 lb-ft).
5. NOTE: RH shown, LH similar.
Tighten the 4 new subframe bracket-to-body bolts to 55 Nm (41 lb-ft).
6. Install the front engine roll restrictor bolt.
-
Tighten to 90 Nm (66 lb-ft).
7. Install the rear engine roll restrictor bolt.
-
Tighten to 90 Nm (66 lb-ft).
Vehicles equipped with EPAS
8. NOTICE: Do not allow the intermediate shaft to rotate while it is disconnected from the gear or damage to the clockspring may occur. If
there is evidence that the intermediate shaft has rotated, the clockspring must be removed and recentered. For additional information,
refer to Restraint Systems.
Install the steering intermediate shaft onto the steering gear and install a new bolt.
-
Tighten to 20 Nm (177 lb-in).
