Flex FWD V6-3.5L (2010)
Parking Brake Cable - Rear
Parking Brake Cable - Rear
Removal and Installation
Both cables
1. Release the parking brake cable tension. For additional information, refer to Parking Brake Cable Tension Release See: Procedures.
RH cable
2. Separate the RH cable from the LH at the conduit equalizer and remove the cable from the wireform bracket.
3. Remove the 3 parking brake cable bracket bolts.
-
To install, tighten to 15 Nm (133 lb-in).
4. Remove the RH wheel well bracket bolt.
-
To install, tighten to 23 Nm (17 lb-ft).
LH cable
5. Disconnect the conduit equalizer from the RH cable at the equalizer.
6. Remove the wireform bracket bolt and separate the LH cable and bracket from the RH cable.
-
To install, tighten bolt to 12 Nm (106 lb-in).
7. Remove the LH wheel well bracket bolt.
