Flex FWD V6-3.5L (2010)
Using the Crankshaft Vibration Damper Installer and Front Cover Oil Seal Installer, install the crankshaft pulley.
37. Using the Strap Wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
-
Stage 1: Tighten to 120 Nm (89 lb-ft).
-
Stage 2: Loosen one full turn.
-
Stage 3: Tighten to 50 Nm (37 lb-ft).
-
Stage 4: Tighten an additional 90 degrees.
38. Install the accessory drive belt tensioner and the 3 bolts.
-
Tighten to 11 Nm (97 lb-in).
39. Install the power steering pump and the 3 bolts.
-
Tighten to 25 Nm (18 lb-ft).
40. NOTE: Installation of new seals is only required if damaged seals were removed during disassembly of the engine.
NOTE: Spark plug tube seal installation shown, VCT seal solenoid installation similar.
Using the VCT Spark Plug Tube Seal Installer and Handle, install new VCT solenoid and/or spark plug tube seals.
