Flex FWD V6-3.5L (2010)
Drive Belt: Service and Repair
Accessory Drive Belt
Accessory Drive Belt - 3.5L
Removal
NOTICE: Under no circumstances should the accessory drive belt, tensioner or pulleys be lubricated as potential damage to the belt material
and tensioner damping mechanism will occur. Do not apply any fluids or belt dressing to the accessory drive belt or pulleys.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the generator
pulley.
3. Remove the 7 pin-type retainers and the RH splash shield.
4. Working from under the vehicle, remove the accessory drive belt.
Installation
1. Working from under the vehicle, position the accessory drive belt on all pulleys, with the exception of the generator pulley.
2. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
3. Install the RH splash shield and the 7 pin-type retainers.
