Flex FWD V6-3.5L (2010)
19. NOTE: It may be necessary to rotate the crankshaft slightly to remove slack from the timing chain and install the tensioner.
Install the primary tensioner and the 2 bolts.
-
Tighten to 10 Nm (89 lb-in).
-
Remove the lockpin.
20. As a post-check, verify correct alignment of all timing marks.
21. Inspect the VCT housing seals for damage and replace as necessary.
22. NOTICE: Make sure the dowels on the Variable Camshaft Timing (VCT) housing are fully engaged in the cylinder head prior to
tightening the bolts. Failure to follow this process will result in severe engine damage.
