Flex FWD V6-3.5L (2010)
-
High mounted stoplamp
-
SJB
PINPOINT TEST J: ONE OR MORE STOPLAMPS ARE INOPERATIVE
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
-------------------------------------------------
J1 DETERMINE THE INOPERATIVE STOPLAMP
-
Ignition OFF.
-
Apply the brake pedal and observe the stoplamps.
-
Are all the stoplamps inoperative?
Yes
GO to Pinpoint Test I. See: Pinpoint Test I: All The Stoplamps Are Inoperative
No
If the high mounted stoplamp is inoperative, GO to J2.
If both rear stoplamps are inoperative, GO to J4.
If an individual rear stoplamp is inoperative, GO to J6.
-------------------------------------------------
J2 CHECK FOR VOLTAGE TO THE HIGH MOUNTED STOPLAMP
-
Disconnect: High Mounted Stoplamp C9040.
-
While applying the brake pedal, measure the voltage between the high mounted stoplamp C9040-1, circuit CCB08 (VT/WH), harness side and
ground.
-
Is the voltage greater than 10 volts?
Yes
GO to J3.
No
REPAIR circuit CCB08 (VT/WH) for an open. TEST the system for normal operation.
-------------------------------------------------
J3 CHECK THE HIGH MOUNTED STOPLAMP GROUND CIRCUIT FOR AN OPEN
-
Measure the voltage between the high mounted stoplamp C9040-1, circuit CCB08 (VT/WH), harness side and the high mounted stoplamp
C9040-2, circuit GD149 (BK/GY), harness side.
