Flex FWD V6-3.5L (2010)
Evaporative Emissions Hose: Service and Repair
Fuel Vapor Tube Assembly
Removal and Installation
1. Remove the fuel tank. For additional information, refer to Fuel Delivery and Air Induction.
2. Disconnect the Fuel Tank Pressure (FTP) sensor electrical connector.
3. Disconnect the fuel vapor tube assembly-to-fuel vapor valve quick connect coupling. For additional information, refer to Fuel Delivery and Air
Induction.
4. Disconnect the fuel vapor tube assembly-to-fuel level sensor quick connect coupling. For additional information, refer to Fuel Delivery and Air
Induction.
5. Release the retainer clips and remove the fuel vapor tube assembly.
6. To install, reverse the removal procedure.
-
Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test See:
