Flex FWD V6-3.5L (2010)
Seat Occupant Classification Module - Air Bag: Service and Repair
Occupant Classification System Module (OCSM) - Power Seat Track
Occupant Classification System Module (OCSM) - Power Seat Track
Removal
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.
2. Disconnect the Occupant Classification System Module (OCSM) electrical connector.
3. Remove the 2 screws and OCSM.
4. To install, reverse the removal procedure.
5. Repower the SRS. Do not prove out the SRS at this time. For additional information, refer to Supplemental Restraint System (SRS) Depowering
and Repowering See: Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering
in the General Procedures.
6. Carry out the Occupant Classification Sensor (OCS) System Reset procedure. For additional information, refer to Occupant Classification Sensor
(OCS) System Reset See: Service and Repair in the General Procedures.