Flex FWD V6-3.5L (2010)
For all other vehicles
2. If the arrow on the SASM ring and the arrow on the sensor housing are misaligned and/or the straight-ahead position of the sensor is not known,
follow these steps to align the sensor prior to installing the sensor:
1. Orient the front wheels in the straight-ahead position.
2. Carefully rotate the sensor clockwise until it stops.
3. Rotate the sensor counterclockwise two and one-half turns.
For all vehicles
3. NOTE: Slight rotation of the SASM ring is allowed to align the 2 arrows.
Make sure the sensor ring arrow is lined up with the SASM housing arrow as shown and position the sensor into the multifunction switch housing.
4. Connect the SASM electrical connector.
5. Install the 2 SASM bolts.
-
Tighten to 1 Nm (9 lb-in).
6. Install the clockspring. For additional information, refer to Restraint Systems.
-
If the SASM was aligned using the scan tool, DTCs will be present in the Restraints Control Module (RCM). Using the scan tool, clear the
DTCs in the RCM.
For Edge and MKX vehicles only
7. Calibrate the ABS module.
-
Carry out the IVD Initialization sequence. Follow the scan tool directions.
