Flex FWD V6-3.5L (2010)
All sensors except GTDI
5. Disconnect the HO2S electrical connector.
All sensors
6. NOTE: If necessary, lubricate the sensor threads with penetrating and lock lubricant to assist in removal.
Using the Exhaust Gas Oxygen Sensor Socket, remove the HO2S.
-
Calculate the correct torque wrench setting for the following torque.
-
To install, tighten to 48 Nm (35 lb-ft).
7. NOTE: Apply a light coat of anti-seize lubricant to the threads of the HO2S.
To install, reverse the removal procedure.