ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Steering - Fluid Leak At Reservoir Cap In Cold Temps.|Page 5567 > < Steering - Fluid Leak At Reservoir Cap In Cold Temps.|Page 5561
Page 1
background image

Power Steering Fluid Reservoir: All Technical Service Bulletins
Steering - Fluid Leak At Reservoir Cap In Cold Temps.

TSB 10-6-1

04/12/10

POWER STEERING FLUID LEAK AT THE RESERVOIR FILL CAP

FORD:
2010 Taurus, Flex

LINCOLN:
2010 MKS, MKT

ISSUE
Some 2010 Taurus, MKS, Flex and MKT vehicles may exhibit a power steering fluid leak at the reservoir fill cap when operated in very cold climates of
ambient temperatures below 0 degrees Fahrenheit (-18 degrees Celsius). Air may enter the system through the pump supply tube-to-pump joint
immediately after a cold start causing the fluid to foam.

ACTION
Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

The Service Procedure must be performed with the vehicle at room temperature.

1. With the vehicle in neutral, position it on a hoist. Refer to Workshop Manual (WSM), Section 100-02.

2. Remove the 7 pin-type retainers and the RH inner fender splash shield. (Figure 1)

Steering - Fluid Leak At Reservoir Cap In Cold Temps.|Page 5567 > < Steering - Fluid Leak At Reservoir Cap In Cold Temps.|Page 5561