Flex FWD V6-3.5L (2010)
9. Connect the 2 EPAS electrical connectors (1 shown) and attach the wiring retainer (not shown) and install the bolt.
-
Tighten to 9 Nm (80 lb-in).
All vehicles
10. NOTE: RH shown, LH similar.
Position the ball joints into the wheel knuckles. Install the new ball joint nuts.
-
Tighten to 200 Nm (148 lb-ft).
11. NOTE: The hex-holding feature can be used to prevent turning of the stud while installing the nuts.
NOTE: RH shown, LH similar.
Install new tie-rod end nuts.
-
Tighten to 150 Nm (111 lb-ft).
12. NOTE: RH shown, LH similar.
Install new upper stabilizer bar link nuts.
-
Tighten to 150 Nm (111 lb-ft).
