Flex FWD V6-3.5L (2010)
actuator rod behind the machined valve body mating surface of the transaxle case. If the park pawl actuator rod becomes disengaged from the park
pawl and the abutment, transaxle removal and disassembly is required to reinstall the actuator rod.
11. NOTE: Make sure that the park pawl actuator rod does not become disengaged from the park pawl and the abutment or transaxle removal and
disassembly is required to reinstall the actuator rod.
Remove the TR sensor.
1. Slide the TR sensor down until the manual shaft is out of the transaxle case.
2. Rotate the TR sensor detent plate counterclockwise, as viewed from below, until the plate rests against the transaxle case, remove the park
pawl actuating rod from the TR sensor and remove the TR sensor.
12. Using a suitable tool, remove the manual control lever shaft seal.
Installation
1. Using the Manual Lever Shaft Seal Installer, install a new manual control lever shaft seal.
2. Install the TR sensor.
1. Position the park pawl actuating rod in the TR sensor.
