Flex FWD V6-3.5L (2010)
2. Install the TR sensor in the transaxle case.
3. Using the Manual Lever Retaining Pin Installer, install a new TR sensor locking pin.
4. NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
5. Inspect the manual pin to make sure it is correctly installed in the manual valve. If not, pull the valve body off the transaxle case. Correctly install
the manual pin in the manual valve and position the valve body in place.
6. Install the TR sensor detent spring and the 10 bolts. Tighten the valve body bolts in the sequence shown.
-
Tighten to 12 Nm (106 lb-in).
