Flex FWD V6-3.5L (2010)
2. Rotate the TR sensor detent plate counterclockwise, as viewed from below, until the plate rests against the transaxle case, remove the park
pawl actuating rod from the TR sensor and remove the TR sensor.
Installation
1. Install the TR sensor.
1. Position the park pawl actuating rod in the TR sensor.
2. Install the TR sensor in the transaxle case.
2. Using the Manual Lever Retaining Pin Installer, install a new TR sensor locking pin.
3. NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
