Flex FWD V6-3.5L (2010)
1. NOTE: If cleaning the main control assembly or inspecting the valves, refer to Main Control Valve Body See: Service and
Repair/Overhaul/Disassembly and Assembly of Subassemblies/Main Control Valve Body. If installing a new main control assembly, continue with
this procedure.
NOTE: Make sure that the manual pin (part of the TR sensor) is correctly installed in the manual valve.
Position the TSS, OSS and TR sensor wiring harnesses aside and install the main control valve body.
2. Inspect the manual pin to make sure it is correctly installed in the manual valve. If not, pull the valve body off the transaxle case. Correctly install
the manual pin in the manual valve and position the valve body in place.
3. Install the TR sensor detent spring and the 10 bolts. Tighten the valve body bolts in the sequence shown.
-
Tighten to 12 Nm (106 lb-in).
4. NOTICE: Do not handle the solenoid body in the leadframe area or by the screens of the solenoid body filter or damage to the solenoid
body may occur.
NOTICE: Use care not to break the alignment tabs when installing the solenoid body filter. Damage to the transaxle will occur if the
solenoid body is not correctly aligned.
NOTICE: Make sure that the filter passage areas are clean of foreign material before installing the filter. Damage to the transaxle will
occur if the filter passages are not clean.