Flex FWD V6-3.5L (2010)
Remove the wheel hub nut.
-
Do not discard at this time.
All-Wheel Drive (AWD) vehicles
4. Remove the RH brake disc. For additional information, refer to Disc Brake System.
All vehicles
5. Remove the bolt from the brake hose bracket.
6. NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part number or equivalent part, if replacement is necessary.
Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make
sure of correct retention of these parts.
NOTICE: Use care when releasing the lower arm and knuckle into the resting position or damage to the ball joint seal or Constant
Velocity (CV) boot may occur.
NOTE: Use the hex-holding feature to prevent the stud from turning while removing the nut.
Remove and discard the lower ball joint nut.
-
Separate the lower ball joint from the wheel knuckle.
7. Using the Front Wheel Hub Remover, separate the halfshaft from the wheel hub.
8. Pull the wheel knuckle outboard and rotate it toward the rear of the vehicle.
-
Secure the wheel knuckle assembly.
9. Remove the 2 lower scrivets from the rubber shield and position the shield aside.
