Focus L4-2.0L (2009)
Communications Control Module: Removal and Replacement
Audio Control Module (ACM)
Audio Control Module (ACM)
Removal and Installation
NOTE: It is not necessary to remove the Audio Control Module (ACM) in order to retrieve the part number. For additional information, refer to Audio
Unit Part Number Retrieval See: Procedures/Audio Unit Part Number Retrieval.
1. NOTE: Module configuration is only required if a new ACM is being installed.
Upload the ACM configuration information to the scan tool.
2. Remove the instrument panel center finish panel.
3. Remove the 4 screws and the ACM.
4. To install, reverse the removal procedure.
-
Download the configuration information to the ACM.
Accessory Protocol Interface Module (APIM)
Accessory Protocol Interface Module (APIM)
