Focus L4-2.0L (2009)
C. Using a file or other suitable tool, smooth the edges of the holes to duplicate the existing clip slot size and shape.
3. Attach the new carpet retainer clip to the existing carpet on both left and right side.
a. Using a drill bit or mechanic's pick, add two 1/8" (3 mm) holes in the carpet retainer clip.
b. Align the new carpet retainer clip to the edge of the carpet and use a mechanic's pick to add two corresponding holes in the carpet.
c. Feed a small tie strap 4" (101 mm) long, 3/64" (1 mm) thick and 3/32" (2 mm) wide (obtained locally) through both holes, tighten, and cut off the
excess.
d. Insert each new carpet retainer into the new retainer slot.
4. Reinstall both door scuff trim panels. Refer to WSM, Section 501-05.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
101508A
2008-2009 Focus: Install
0.5 Hr.
New Carpet Retainers (Do
Not Use With Any Other
Labor Operations)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
7013000
07
Disclaimer