Focus L4-2.0L (2009)
4. Place patch 1 into position. (Figure 1 for 2 door model) (Figure 2 for 4 door model)
CAUTION
SOME STATE VOLATILE ORGANIC COMPOUND (VOC) REGULATIONS MAY PROHIBIT THE USE OF THIS ALCOHOL/WATER
SOLUTION. FOR EXAMPLE, THE CALIFORNIA SOUTH COAST AIR QUALITY MANAGEMENT DISTRICT PROHIBITS USE OF THIS
SOLUTION WITHOUT A PERMIT OR A REGULATORY EXEMPTION. YOU SHOULD CHECK WITH YOUR STATE ENVIRONMENTAL
AUTHORITIES TO DETERMINE WHETHER USE OF THIS SOLUTION IS RESTRICTED OR PROHIBITED.
NOTE
ALCOHOL AND WATER SOLUTION MIX RECOMMENDATION IS: 25% ISOPROPYL ALCOHOL (OBTAIN LOCALLY) AND 75%
WATER.
NOTE
SPRAYING THE PATCHES WITH THIS SOLUTION WILL HELP WASH THE SOAP AND WATER SOLUTION AWAY AND WILL
ALLOW THE SQUEEGEE TO SLIDE EASILY. KEEPING THE ADHESIVE WET DURING APPLICATION WILL AID IN POSITIONING
PATCHES.
5. Using a second solution of isopropyl alcohol and water, lift up a portion of the film to the half-way point and spray both sides of the film and the
vehicle with the alcohol and water solution.
6. Secure the patch into the desired position by using the alcohol and water solution and a squeegee at the far end of the application. Some stretching
may be required.
7. Spray the patch again with the alcohol and water solution.
8. Using the squeegee, work from the center and slide the squeegee towards the edges of the patch. This motion pushes out any remaining soap and
water solution as well as any air bubbles that may have formed.
NOTE
