Focus L4-2.0L (2009)
-
Striking effort must be high enough to snap the head restraint guide sleeve retainer in place in the backrest frame.
6. Inspect the head restraint guide sleeve.
-
Pull the head restraint guide sleeve out by hand, making sure it is locked in place. If the head restraint guide sleeve can be removed by hand,
repeat the installation procedure. If the head restraint guide sleeve can be removed again after installing a second time, install a new head
restraint guide sleeve.
7. Repeat these steps for the head restraint guide sleeve on the opposite side.
8. After installation of 2 new head restraint guide sleeves, install the head restraint in the following sequence.
1. Position the head restraint rods to the head restraint guide sleeve holes.
2. Push the head restraint down, guiding the rods into the head restraint guide sleeve holes.
3. Make sure the head restraint adjusts without excessive effort and locks in place.
