Focus L4-2.0L (2009)
Seat Cushion: Removal and Replacement
Seat Cushion Cover - Rear
Seat Cushion Cover - Rear
Removal and Installation
1. Remove the rear seat cushion.
-
Locate the cushion latch releases under the cushion front edge.
-
Push to release the 2 latches and remove the cushion.
2. Remove all the hog rings from the outer edge of the cushion cover.
3. Invert the cushion cover and remove all the inner rows of hog rings.
4. Remove the cushion cover.
5. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
Seat Bolster - Rear
Seat Bolster - Rear
NOTE: RH shown, LH similar.
Removal and Installation
1. Remove the rear seat cushion.
-
Locate the cushion latch releases under the cushion front edge.
-
Push to release the 2 latches and remove the cushion.
2. Remove the seat bolster nut from the lower stud.
-
To install, tighten to 6 Nm (53 lb-in).
3. From the luggage compartment, release the upper retainer behind the seat bolster and remove.
-
If installing a new seat bolster, install a new upper retainer.