Focus L4-2.0L (2009)
Brake Drum: Service and Repair
Brake Drum
Removal
1. Remove the wheel and tire.
2. Remove and discard the dust cap.
3. NOTICE: Do not use power tools to remove the wheel hub nut or damage to the spindle may occur.
NOTICE: If the bearing inner race(s) become separated from the bearing assembly, a new bearing must be installed. Reassembly and
installation of the bearing that has become disassembled will result in bearing failure.
Remove and discard the wheel hub nut and remove the brake drum.
Installation
1. NOTICE: When tightening the new wheel hub nut, rotate the brake drum counterclockwise until the correct torque is achieved or
damage to the wheel bearing may occur.
NOTICE: Avoid impact on the wheel speed sensor ring and any contact between the sensor ring and a magnetic surface or damage to the
sensor ring may occur. Make sure the wheel speed sensor ring is clean or sensor failure may occur.
NOTICE: A new wheel hub nut must be installed or incorrect clamp load may occur resulting in wheel bearing failure.
Position the brake drum and wheel hub assembly and install a new wheel hub nut.
-
While rotating the brake drum in the opposite direction, tighten the wheel hub nut to 235 Nm (173 lb-ft).
2. NOTICE: A new dust cap must be installed or bearing failure may occur.
Install a new dust cap.
3. Install the wheel and tire.
