Focus L4-2.0L (2009)
5. Remove the stoplamp switch.
6. Disengage the tabs and remove the brake booster actuating rod pin.
-
Discard the brake booster actuating rod pin.
-
Disconnect the brake booster actuating rod from the brake pedal.
7. Remove the brake booster nuts.
-
To install, tighten to 23 Nm (17 lb-ft).
8. Remove the brake booster.
9. NOTICE: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch or the speed control deactivator
switch. These switches must be installed with the booster push rod attached to the brake pedal and with the brake pedal in the at-rest
position. Installing these switches with the brake pedal in any other position will result in incorrect adjustment and may damage the
switches.
To install, reverse the removal procedure.
-
Make sure the brake booster gasket is correctly positioned on the brake booster before installation.
-
Make sure that the brake booster actuator rod is correctly positioned through the bulkhead rubber boot.
-
Install a new brake booster actuating rod pin.
