Focus L4-2.0L (2009)
Oil Filter Adapter: Service and Repair
Oil Filter Adapter
Oil Filter Adapter
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.
3. Remove the EOP switch.
4. Remove and discard the oil filter.
5. Remove the 4 bolts and the oil filter adapter.
-
Discard the gasket.
Installation
1. Using a new gasket, install the oil filter adapter and the 4 bolts.
-
Tighten to 25 Nm (18 lb-ft).
2. NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing the oil filter.
Install a new oil filter.
-
Tighten the oil filter three-fourths turn after the oil filter gasket makes contact with the oil filter adapter.
3. NOTE: Apply thread sealant to the EOP switch threads.
Install the EOP switch.
-
Tighten to 15 Nm (133 lb-in).
4. Connect the EOP switch electrical connector.
5. Top off the engine with clean engine oil.
