Focus L4-2.0L (2009)
4. Install the accessory drive idler pulley.
5. Lower the engine to the installed position.
6. Install the engine mount. For additional information, refer to Engine Mount See: Drive Belts, Mounts, Brackets and Accessories/Engine
Mount/Service and Repair/Removal and Replacement.
7. Install the power steering pump.
8. Install the coolant expansion tank.
9. Install the coolant pump pulley and the 3 bolts.
-
Do not tighten at this time.
10. NOTE: Remove the through-bolt from the Camshaft Front Oil Seal Installer.
NOTE: Lubricate the oil seal with clean engine oil.
Using the Camshaft Front Oil Seal Installer, install the crankshaft front oil seal.
11. Install the crankshaft pulley. For additional information, refer to Crankshaft Pulley See: Cylinder Block Assembly/Harmonic Balancer -
Crankshaft Pulley/Service and Repair/Crankshaft Pulley.
12. NOTICE: Only hand-tighten the bolt or damage to the front cover can occur.
Install a standard 6 mm x 18 mm bolt through the crankshaft pulley and thread it into the front cover.
13. Install the CKP sensor and the 2 bolts.
-
Do not tighten the bolts at this time.
