Focus L4-2.0L (2009)
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 2 bolts and position aside the coolant expansion tank.
-
To install, tighten to 4 Nm (35 lb-in).
3. Loosen the 3 coolant pump pulley bolts.
4. Remove the accessory drive belt.
5. Drain the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Cooling System/Service and
Repair/Procedures/Cooling System Draining, Filling and Bleeding.
6. Remove the 3 coolant pump pulley bolts and the pulley.
-
To install, tighten to 20 Nm (177 lb-in).
7. NOTICE: Make sure the coolant pump is correctly seated to the engine block before installing and tightening the fasteners, or damage to
the coolant pump may occur.
Remove the 3 coolant pump bolts and the coolant pump.
-
To install, tighten to 10 Nm (89 lb-in).
8. NOTE: Install a new coolant pump O-ring seal and lubricate with clean engine coolant.
To install, reverse the removal procedure.
9. Fill and bleed the cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding See: Cooling
System/Service and Repair/Procedures/Cooling System Draining, Filling and Bleeding.