Focus L4-2.0L (2009)
Blower Motor Resistor: Service and Repair
Blower Motor Resistor
Removal and Installation
1. Lower the glove compartment.
2. Disconnect the blower motor resistor electrical connector.
3. NOTE: To detach the blower motor resistor from the housing, slide the resistor to the right and lift upward.
Detach and remove the blower motor resistor.
4. NOTE: The blower motor resistor is not equipped from the factory with a mounting screw. A backup screw boss is provided where a screw can be
installed if the blower motor resistor does not clip securely to the heater core and evaporator core housing.
To install, reverse the removal procedure.
