Focus L4-2.0L (2009)
Compass: Description and Operation
Electronic Compass
The compass display is incorporated into the Front Display Interface Module (FDIM).
The compass signal originates from the compass module, which is integrated into the interior rear view mirror.
The MODE button that allows the driver to operate the calibration and zone setting procedures is located on the center bottom of the interior rear view
mirror. The vehicle heading is displayed as a 1 or 2 character display located in the lower LH side of the FDIM and indicates the current direction of the
vehicle (N, NE, E, SE, S, SW, W, or NW). The compass continuously re-calibrates due to changes in the magnetic field and remains accurate during
most driving conditions. The compass display is on with the key in the ON or START position. When the key is first turned to the ON or START
position, there is a momentary delay of approximately 6 seconds before the compass display illuminates. If the battery saver has been activated and the
key is turned to ON or START, the momentary delay before the compass display illuminates is approximately 3 seconds. The compass display will turn
off as soon as the key is turned to the OFF or ACC position.
Compass Accuracy
Driving near power lines, or driving in the area of large iron or steel structures can temporarily change the compass heading. If the compass remains
inaccurate after driving near such objects, calibrate the compass. Refer to Compass Calibration See: Adjustments/Compass Calibration.
Most geographic areas (zones) have a magnetic north compass point that varies slightly from the northerly direction on maps. This variation is 4 degrees
between the adjacent zones and becomes noticeable as the vehicle crosses multiple zones. A correct zone setting eliminates the error. Refer to Compass
Zone Adjustment See: Adjustments/Compass Zone Adjustment.
