Focus L4-2.0L (2009)
-
To install, tighten to 15 Nm (133 lb-in).
5. Remove the 2 Evaporative Emission (EVAP) canister purge valve heat shield pin-type retainers and remove the shield.
6. Remove the 2 EVAP canister purge valve bracket bolts.
7. Remove the Thermostatic Expansion Valve (TXV) fitting nut and disconnect the fitting.
-
Discard the gasket seals.
-
To install, tighten to 15 Nm (133 lb-in).
8. Disconnect the A/C pressure transducer electrical connector.
9. Remove the condenser-to-evaporator line bracket bolt at the RH shock tower.
-
To install, tighten to 11 Nm (97 lb-in).
10. Remove the 2 coolant reservoir bolts and position the coolant reservoir aside.
11. Detach the condenser-to-evaporator line from the inner fender and remove the line.
12. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
13. Evacuate, leak test and charge the refrigerant system.
