Focus L4-2.0L (2009)
Diagrams/Diagrams By Number
Refer to Wiring Diagrams Set 130, Audio System for schematic and connector information. See: Diagrams/Electrical Diagrams/Diagrams By Number
Normal Operation
The Front Controls Interface Module (FCIM) communicates with the scan tool through the Medium Speed Controller Area Network (MS-CAN).
Circuits VDB06 (GY/OG) (MS-CAN +) and VDB07 (VT/OG) (MS-CAN -) provide the network connection to the FCIM. Voltage to the FCIM is
provided by circuit SBP39 (WH/RD). Ground is provided by circuit GD110 (BK/VT).
This pinpoint test is intended to diagnose the following:
-
Fuse
-
Wiring, terminals or connectors
-
FCIM
PINPOINT TEST G: THE FCIM DOES NOT RESPOND TO THE SCAN TOOL
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
G1 CHECK THE FCIM VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: FCIM C2402.
-
Ignition ON.
-
Measure the voltage between the FCIM C2402-1, circuit SBP39 (WH/RD), harness side and ground.
-
Is the voltage greater than 10 volts?
Yes
GO to G2.
No
VERIFY the SJB fuse 39 (20A) is OK. If OK, REPAIR the circuit in question. If not OK, REFER to the Wiring Diagrams to identify the possible causes
of the circuit short. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
G2 CHECK THE FCIM GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Measure the resistance between the FCIM C2402-2, circuit GD134 (BK/VT), harness side and ground.
