Focus L4-2.0L (2009)
-------------------------------------------------
L9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE FDIM DISCONNECTED
NOTE: When re-running the network test, the network test application must be closed first or the screen display reverts back to the prior run network
test results.
-
Disconnect: FDIM C2123.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the FDIM. Go To Pinpoint Test H. See: Pinpoint Test H: The Front Display Interface Module (FDIM) Does Not Respond To The Scan
Tool
No
CONNECT the FDIM. Go To Pinpoint Test G. See: Pinpoint Test G: The Front Controls Interface Module (FCIM) Does Not Respond To The Scan
Tool
-------------------------------------------------
L10 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must be closed first or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuse 13 (5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test F. See: Pinpoint Test F: The Accessory Protocol Interface Module (APIM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuse. GO to L11.
-------------------------------------------------
L11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must be closed first or the screen display reverts back to the prior run network
test results.
-
Disconnect: SJB Fuses 26 (10A) and 29 (5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test C. See: Pinpoint Test C: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. GO to L12.
-------------------------------------------------
L12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISCONNECTED
-
Disconnect: IC C220.
-
Enter the following diagnostic mode on the scan tool: Network Test.
